Defender Roof Bar Set

Ideal for mounting a roof tent or other accessories where a low profile and smaller footprint is preferred.
Utilize the same 22mm thick HD aluminium extrusions (slats) as the Slimline Roof Rack.
The sliding nut t-slots allow quick fit and removal of accessories and equipment.
The t-slots are located on both the upper and lower faces of the load bars and are used for the mounting the feet as well as accessories.

Specifications

Consisting of:

• 1 x FITT002 - Fitting Instruction - Kit Vehicle Specific
• 2 x LASS107 - No 7 Leg 225mm (Pair)
• 1 x LBSK016 - Load Bar Pair 1425mm
• 1 x WDLB001 - Roof Load Bar Wind Deflector 10mm

 
Material used:

• Black epoxy powder-coated T6 aluminium
• 3CR12 Stainless Steel

Approximate Installed Weight 8kg (18lbs)

The t-slots on the tops and bottoms of the slats accommodate standard 8mm bolts.
To determine the approximate height from your vehicle’s roof to the top of your Load Bar Kit, add the height of the Load Bar (22mm/ 7/8") to the height of the Foot, Grab-On Foot, or Strap-On Foot listed above.

If your Load Bar kit uses Legs, add the height of the Load Bar (22mm/ 7/8") to the height of the Legs listed above to determine the height of the rack from your vehicle’s rain gutters.

If your Load Bar kit uses Foot Rails, add the height of the Load Bar (22mm/ 7/8") to the height of the Foot Rails listed above to determine the height of the rack from the crown (highest point) of the vehicles roof.
 
Shipping Dimensions:

• Width 130mm (5")
• Length 1540mm (61")
• Height 195mm (8")

Shipping Weight:

• Weight 9.4kg (20.8lbs)

KRLD024 - Front Runner Load Bar Kit / Land Rover Defender