Workshop Projects
- 110 Trayback
- » Introduction
- » General Design
- » Starting the build
- » Cab modification
- » Front Wings
- » Cleaning the chassis
- » Roll Cage
- » Engine positioning
- » Bulkhead Modification
- » Fuel tank mounting
- » Rear winch cradle
- » Roll Cage Mounts
- » Engine Mounts
- » Main Tray Structure
- » Tray Extras
- » Rear Storage
- » Chassis Finishing
- » Engine Build
- » Axle Cases
- » Building up the chassis
- » Gearbox fitting
- » Propshafts
- » Bulkhead / Cab Fitting
- » Rear tray panels
- » ECU
- » Brake Pipes
- » Fuel Fillers
- » Fuel tank guards
- » Transmission Guard
- » Exhaust headers
- » Raised Air Intake
- » Wheels and Tyres
- » Fuel System
- » Cooling Packs
- » Body Panels
- » Wiring Looms
- » Air temperature sensor
- » Batteries fitted
- » Cooling Pipework
- » ARB Compressor
- » Rear Lights
- » Gearbox Tunnel
- » Graphics
- » Winches
- » Roof Lights
- » Exhaust
- » Gauges
- » Cooling Fans
- » Helmets
- » Side vent
- » GPS Navigation
- » Extra fuel storage
- » ARB diff locker controls
- » Window Nets
- » Kit Storage
- » Waterproofing
- » Seat belt mounts
- » Rear shock mounts
- » Tarting up
- » Finished Vehicle
- Challenge 90 Rebuild
- Range Rover Bobtail
- Standard Class Challenge Truck
- Toyota Hilux Invincible Expedition Build
110 Trayback / Starting the build
The first job was to strip the 110 down to a chassis cab and give it a good steam clean.
This is the stage where there is more discussion than action; it’s the time where all the major decisions will take place.
Once clean we placed the 110 in the workshop and removed the rear chassis over hang and any unnecessary out riggers.
This is the stage where there is more discussion than action; it’s the time where all the major decisions will take place.
Once clean we placed the 110 in the workshop and removed the rear chassis over hang and any unnecessary out riggers.
Previous
