Workshop Projects
- 110 Trayback
- » Introduction
- » General Design
- » Starting the build
- » Cab modification
- » Front Wings
- » Cleaning the chassis
- » Roll Cage
- » Engine positioning
- » Bulkhead Modification
- » Fuel tank mounting
- » Rear winch cradle
- » Roll Cage Mounts
- » Engine Mounts
- » Main Tray Structure
- » Tray Extras
- » Rear Storage
- » Chassis Finishing
- » Engine Build
- » Axle Cases
- » Building up the chassis
- » Gearbox fitting
- » Propshafts
- » Bulkhead / Cab Fitting
- » Rear tray panels
- » ECU
- » Brake Pipes
- » Fuel Fillers
- » Fuel tank guards
- » Transmission Guard
- » Exhaust headers
- » Raised Air Intake
- » Wheels and Tyres
- » Fuel System
- » Cooling Packs
- » Body Panels
- » Wiring Looms
- » Air temperature sensor
- » Batteries fitted
- » Cooling Pipework
- » ARB Compressor
- » Rear Lights
- » Gearbox Tunnel
- » Graphics
- » Winches
- » Roof Lights
- » Exhaust
- » Gauges
- » Cooling Fans
- » Helmets
- » Side vent
- » GPS Navigation
- » Extra fuel storage
- » ARB diff locker controls
- » Window Nets
- » Kit Storage
- » Waterproofing
- » Seat belt mounts
- » Rear shock mounts
- » Tarting up
- » Finished Vehicle
- Challenge 90 Rebuild
- Range Rover Bobtail
- Standard Class Challenge Truck
- Toyota Hilux Invincible Expedition Build
110 Trayback / Raised Air Intake
My next task was the raised air intake; this is a job that requires patience and a bit of piece and quiet, in other words, over the weekend. I had an idea of what I wanted so the best way forward was to get the main tube mounted and work from there.
I use a series of 90 degree and 45 degree bends welded together to create the shape that I want. I tack them together on the vehicle and then remove for welding, when satisfied I then linish out the welds.
For simplicities sake I chose to use a Greens air filter, I have to say that it coped admirably, however I would use a different system for the future which will comprise of standard flat panel filters.
I use a series of 90 degree and 45 degree bends welded together to create the shape that I want. I tack them together on the vehicle and then remove for welding, when satisfied I then linish out the welds.
For simplicities sake I chose to use a Greens air filter, I have to say that it coped admirably, however I would use a different system for the future which will comprise of standard flat panel filters.
Previous
