Workshop Projects
- 110 Trayback
- » Introduction
- » General Design
- » Starting the build
- » Cab modification
- » Front Wings
- » Cleaning the chassis
- » Roll Cage
- » Engine positioning
- » Bulkhead Modification
- » Fuel tank mounting
- » Rear winch cradle
- » Roll Cage Mounts
- » Engine Mounts
- » Main Tray Structure
- » Tray Extras
- » Rear Storage
- » Chassis Finishing
- » Engine Build
- » Axle Cases
- » Building up the chassis
- » Gearbox fitting
- » Propshafts
- » Bulkhead / Cab Fitting
- » Rear tray panels
- » ECU
- » Brake Pipes
- » Fuel Fillers
- » Fuel tank guards
- » Transmission Guard
- » Exhaust headers
- » Raised Air Intake
- » Wheels and Tyres
- » Fuel System
- » Cooling Packs
- » Body Panels
- » Wiring Looms
- » Air temperature sensor
- » Batteries fitted
- » Cooling Pipework
- » ARB Compressor
- » Rear Lights
- » Gearbox Tunnel
- » Graphics
- » Winches
- » Roof Lights
- » Exhaust
- » Gauges
- » Cooling Fans
- » Helmets
- » Side vent
- » GPS Navigation
- » Extra fuel storage
- » ARB diff locker controls
- » Window Nets
- » Kit Storage
- » Waterproofing
- » Seat belt mounts
- » Rear shock mounts
- » Tarting up
- » Finished Vehicle
- Challenge 90 Rebuild
- Range Rover Bobtail
- Standard Class Challenge Truck
110 Trayback / Front Wings
Next was to remove the front wings, as the panels were damaged it was a simple operation to cut off the wing skins to give easy access to the fixing bolts, the wing tops were destined to be re used. Whilst this was going on Matt removed the seat box and floor pans.
Previous
|
|
