Workshop Projects
- 110 Trayback
- » Introduction
- » General Design
- » Starting the build
- » Cab modification
- » Front Wings
- » Cleaning the chassis
- » Roll Cage
- » Engine positioning
- » Bulkhead Modification
- » Fuel tank mounting
- » Rear winch cradle
- » Roll Cage Mounts
- » Engine Mounts
- » Main Tray Structure
- » Tray Extras
- » Rear Storage
- » Chassis Finishing
- » Engine Build
- » Axle Cases
- » Building up the chassis
- » Gearbox fitting
- » Propshafts
- » Bulkhead / Cab Fitting
- » Rear tray panels
- » ECU
- » Brake Pipes
- » Fuel Fillers
- » Fuel tank guards
- » Transmission Guard
- » Exhaust headers
- » Raised Air Intake
- » Wheels and Tyres
- » Fuel System
- » Cooling Packs
- » Body Panels
- » Wiring Looms
- » Air temperature sensor
- » Batteries fitted
- » Cooling Pipework
- » ARB Compressor
- » Rear Lights
- » Gearbox Tunnel
- » Graphics
- » Winches
- » Roof Lights
- » Exhaust
- » Gauges
- » Cooling Fans
- » Helmets
- » Side vent
- » GPS Navigation
- » Extra fuel storage
- » ARB diff locker controls
- » Window Nets
- » Kit Storage
- » Waterproofing
- » Seat belt mounts
- » Rear shock mounts
- » Tarting up
- » Finished Vehicle
- Challenge 90 Rebuild
- Range Rover Bobtail
- Standard Class Challenge Truck
110 Trayback / Gearbox Tunnel
Because we had moved the engine back by about 150mm we needed to move the hi/low lever in order for it to clear the seat box
Traditionally I have always made the gear box tunnel in one piece but this time I chose to make it very quick to remove the top section so that should we have a problem it would be easy to access the hi/low controls.
Once made, the under side of the tunnel was covered with a heat resistant material in an effort to prevent the heat entering the cab.
Traditionally I have always made the gear box tunnel in one piece but this time I chose to make it very quick to remove the top section so that should we have a problem it would be easy to access the hi/low controls.
Once made, the under side of the tunnel was covered with a heat resistant material in an effort to prevent the heat entering the cab.
Previous
|
|
